Premium / Antireflex / Plus
1. Thoroughly clean the screen
(The display must be completely free of dust and grease. Please refer to the cleaning instructions of the manufacturer)
2. Remove the backing paper in half
3. Position the film at the edge of the display and apply
If you are not satisfied with the results, pull the film off as much as necessary and repeat the steps. (Note: Crocfol accepts no liability for improper handling)
Antireflex
7. Thoroughly clean the screen
(The display must be completely free of dust and grease. Please refer to the cleaning instructions of the manufacturer)
8. Remove the backing paper in half
9. Position the film at the edge of the display and apply
If you are not satisfied with the results, pull the film off as much as necessary and repeat the steps. (Note: Crocfol accepts no liability for improper handling)
Plus
1. Clean the display with a lint-free cloth (such as wet & dry by Crocfol)
2. Apply a few drops of a water/detergent mixture to the centre of the display
3. Use the two supplied pieces of tape to attached to the film on the left and right side. Use these to handle the film with out touching it directly.
4. Remove the backing paper on the adhesive side (Caution: Do not touch adhesive side!)
5. Position the film over the display.
6. Adjust the film if necessary
7. Lightly move your thumb across the film to remove any bubbles, starting in the middle and moving towards the sides of the display.
8. Leave film to dry for about 30 minutes, until it develops its full adhesion
9. Remove the two pieces of tape
It may be that shadows are visible when first applied. This is not due to any defect but is normal and they will disappear after a few days. (Note: Crocfol accepts no liability for improper handling)
Art / Skin
The Art/Skin films are easy to apply without any bubbles and can be removed without leaving any residue. If it does not fit perfectly on the first try - no problem: just peel it back and start again. Once you find the right position just smooth the surface with your thumb and only then will it fully stick. You simply flatten out any bubbles with your thumb or palms by smoothing the surface from the center outward. By the way, you can also cover traces of usages such as scratches with Art/Skin. If you want to remove the Art/Skin film later, please be extra careful. It's best to warm the film up lightly with a hair dryer before removing it. The film can then be removed more easily. All this can also be found in the instructions supplied with each Art/Skin film.
Art
The Art film is easy to apply without any bubbles and can be removed without leaving any residue. If it does not fit perfectly on the first try - no problem: just peel it back and start again. Once you find the right position just smooth the surface with your thumb and only then will it fully stick. You simply flatten out any bubbles with your thumb or palms by smoothing the surface from the centre outward. By the way, you can also cover traces of usages such as scratches with Art. If you want to remove the Art film later, please be extra careful. It's best to warm the film up lightly with a hair dryer before removing it. The film can then be removed more easily. All this can also be found in the instructions supplied with each Art film.
Magic Switch
1. Thoroughly clean the screen
(The display must be completely free of dust and grease. Please refer to the cleaning instructions of the manufacturer)
2. Remove the backing paper in half
3. Position the film at the edge of the display and apply
If you are not satisfied with the results, pull the film off as much as necessary and repeat the steps. (Note: Crocfol accepts no liability for improper handling)
cheap web hosting packages
